- 18 -
Gelovit 200
Timer
With the timer the unit can be switched on such that
finished duplicating material is available at the
operating temperature at a preselected time.
Example: At 4 p.m. on Friday the timer is to be set so
that the unit switches on at 6 a.m. on Monday:
8 (Friday) + 24 (Saturday) + 24 (Sunday) +
6 (Monday) = 62 hours.
1 Press button briefly: the last set time (hours) is
displayed.
2 If necessary, change the time by pressing the "+"
and "-" buttons.
(Holding the button down accelerates the
adjustment procedure.)
Press button 1 again briefly to switch off the time
display and store the altered time.
Note:
If button 1 is not pressed again, the time display
switches off automatically after approx. 10
seconds. The altered time is stored.
3 Start timer: press button 3.
z The display shows the remaining time until the
unit is switched on (hours:minutes).
z Lamps T1 to T3 flash in succession (running
light).
Leave main power switch switched on!
z Stop timer: press button 3 again.
The display indicates the actual temperature of the
duplicating material.
Then press T1 - T3 as required.
1
6 2 0 0
2
3
Operation
°C
°F
To Next Page
Loading...
