Bego Gelovit 200 - Filling; Filling Procedure and Safety

30
85980 BA-en/05 334.00171…
English ⋅ Gelovit 200
en
Filling
1. Open the cover.
2. Fill with fist-size pieces of duplicating material:
minimum of 3 kg, maximum of 6 kg.
3. Close the cover and turn so that it is locked.
The heating system and mixer only work when
the cover is locked.
WARNING
Burn hazard from hot parts!
• During the melting process the
housing and cover become hot! Let
the unit cool down or use safety
gloves before touching the cover.
• Be careful when reaching into the
container. Pull out the mains plug
before reaching in!
• The agitator has sharp edges!
• The container may be very hot!
NOTE
• Used duplicating material can be re-utilised, but
must first be melted. Clean used duplicating
material carefully with water. Do not put used
duplicating material in the container until imme-
diately before the next melting operation.
• Do not forget: After filling the unit with fresh
duplicating material, you must reset the counter
for the melting cycles to 0 (press the "+" und "-
" buttons simultaneously and keep them
depressed until the acoustic signal sounds
twice).