Behringer 2500 - Page 14

Controls
1. LEDs - Indicate whether the
associated knob is active. !
2. NOISE knob - Attenuates the output
of the noise generator!
3. SLOW RANDOM knob - Attenuates
the output of the slow random
voltage generator. !
4. WHITE/PINK/OFF switch - Selects
between white or pink noise or,
disengage the output. !
5. OFF/ON switch - Engages or
disengages the slow random voltage
generator. !
Patchpoints!
6. NOISE A/B - Send the noise A and B
signals to other modules via 3.5 mm
TS cable. !
7. RANDOM A/B - Send the random
voltage signals to other modules via
3.5 mm TS cable.