1. ATTACK TIME - Adjusts the rate at
which the envelope reaches its
peak voltage.!
2. SIGNAL LED - Indicates when a
gate signal is present.!
3. INITIAL DECAY TIME - Adjusts the
rate at which the envelope decays
from its peak to its designated
sustain level.!
4. SUSTAIN LEVEL - Controls the
level at which the envelope remains
after its peak but before release,
sustaining as Long as the input
signal is present or the manual gate
button is held down.!
5. FINAL DECAY TIME - Controls
how quickly the envelope falls after
the input signal stops or the manual
gate button is released. !
6. TRIGGER MODE - Selects
between single mode, where only
the gate signal controls the
envelope, or multiple mode, which
uses a positive trigger pulse to re-
trigger the envelope while a gate
signal is present.!
7. MANUAL GATE - Press and hold to
start the envelope cycle.!
Patchpoints
8. GATE - Connect a gate signal to
control the envelope cycle.!
9. TRIG- Triggers a new attack of the
envelope if a gate signal is also
present.!
10. OUT L - Send the left envelope
positive and negatieve control
voltage to other modules via
3.5 mm TS cable.!
11. OUT R - Send the right envelope
positive and negatieve control
voltage to other modules via
3.5 mm TS cable.
To Next Page
Loading...
