1. COARSE FREQUENCY - Sets the
frequency from 0.03 to 32 Hz in the
low (LFO) range, or from 15,5 Hz to
16 kHz in the high (audio) range,
depending on the Fine frequency
knob setting.!
2. FINE FREQUENCY - Adjusts the
frequency by a factor of ±1 octave,
potentially halving or doubling the
frequency at either extreme. !
3. ENABLE switch - Turns the oscillator
on and off.!
4. RANGE switch - Determines
whether the oscillator operates in the
low (subsonic/LFO) band or the high
(audio) band. !
5. WAVEFORM switches - Engage up
to 5 waveforms by moving the
relevant toggle switch to the left, or
engage the inverse waveform by
moving the switch to the right.
The center position turns the
waveform off. Engaging multiple
switches simultaneously produces
the average of all active waveforms.!
6. PW knob - Manually control the
pulse width for the pulse waveform.!
7. FM 2 knob - Attenuates the signal
connected to the FM 2 input.!
8. PWM knob - Adjusts the modulation
depth of the PWM control input.!
9. FM 1 knob - Attenuates the signal
connected to the FM 1 input.!
Patchpoints!
10. KYBD - Connect a keyboard or other
external frequency control via a
3,5 mm TS cable.!
11. FM 1/2 - Connect external voltages
to modulate the frequency.!
12. PWM - Connect an external voltage
to modulate the pulse width.!
13. OUT - Send the oscillator signal
other modules via 3,5 mm TS cable.
To Next Page
Loading...
