EasyManua.ls Logo

Behringer EUROLIVE F1320D - EUROLIVE F1320 D Controls; Power and Level Controls

Behringer EUROLIVE F1320D
11 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
LIMITED WARRANTY
For the applicable warranty terms and conditions and additional information regarding MUSIC Group’s Limited
Warranty, please see complete details online at music-group.com/warranty.
8 EUROLIVE F1320D
EUROLIVE F1320D Controls
Controls
First group control
(1) The POWER LED lights up when the loudspeaker is put into operation.
(2) The CLIP LED lights up when signal distortion occurs. Reduce the volume with the LEVEL
control until the CLIP LED does not light up any more, or occasionally lights up at signal peaks.
(3) To set the volume of the LINE or MIC signal, use the LEVEL control. The left half of the control range is for
attenuating the LINE signal. The right half is for raising the level of the MIC signal.
LEVEL ADJUSTING: Turn the LEVEL control whose signal you want to adjust slowly to the right until the CLIP LED
(2) lights up only at signal peaks. The LED is not supposed to glow continuously.
Equalizer
(4) The F1320D features a 3-band sound control. Each band provides a maximum boost/cut of 15 dB. At center
position the equalizer has a flat response.
The upper (EQ HIGH) and the lower band ( EQ LOW) are shelving filters that boost and cut all frequencies above and
below the crossover frequency. The crossover frequencies of the upper and lower bands are at 12 kHz and 80 Hz,
respectively. The mid band (EQ MID) is a peak filter the center frequency of which is at 2.5 kHz.

Other manuals for Behringer EUROLIVE F1320D

Related product manuals