20
2.3.4 Direct output on each Main input channel
Fig. 2.10: Using the direct outputs for multi-track recording
The MX3242X has four Subgroups which can be used to feed a multi-track recorder. However, it is often
necessary to record more than 4 tracks at the same time. For this reason, your EURORACK MX3242X has a
post-fader direct output for each Main input channel, which allows you to record up to 16 tracks
simultaneously.
If that isnt enough, you can also use the various routing options for the Aux Returns to connect line-level
signal sources. The signals are routed from there to the Subgroups and ultimately to the multi-track recorder.
Of course, you can also create a direct link by fitting a cable with a special ¼" mono phone plug (tip =
ground; sleeve = signal) to feed the signals directly via the inserts to the Subgroups. In this configuration, you
can record a maximum of 20 individual signals at the same time ... with a 12 rack units console!
2.4 Main section
2.4.1 Aux Send buses
Fig. 2.11: Aux Send Main section
Aux Sends are on ¼" phone jacks . Their level can be adjusted with the master controls for Aux Sends 1
through 6 located in the Main section. Beyond the center detent position (unity gain), these controls give
you up to 15 dB gain, which should be more than enough to drive any effects unit. The SOLO buttons
enable you to monitor the Aux signals via the MON OUTput . When the SOLO function is on, its control
LED lights up (for Aux Sends 1, 3, 5 or 2, 4, 6).
2. OPERATION
To Next Page
Loading...
