Behringer Minimon MON800 - Page 9

MINIMON MON800 Controls
(EN) Controls
For more details on the full functionality of this product,
see the product page on behringer.com and download the
full manual.
(1) (2)
(3) (8) (11) (12) (13)(6)
(4) (7) (9) (10)(5)
(14) (17)(16)
(15)
(18) (19) (20) (21) (22)
(1) Use the four switches in the SOURCE section to select up to four
input sources (MIX A and B, CD/TAPE C and D) for monitoring
and recording.
(2) The two LED displays are for monitoring the output level of the
2-TRACK OUT outputs. They comprise 6 LEDs each. When the
CLIP LED lights up, thisindicates that distortion may occur.
(3) A pair of headphones with a ¼" TRS connector
(e.g. BEHRINGER HPS5000) can be connected to the
PHONES jack. This output is wired in parallel with the
rear-panel output jack (15), so that up to two headphones
can be used at the same time.
(4) With the PHONES LEVEL control you can adjust the
volume for the two headphones jacks on the front or rear
panel respectively.
(5) SPK A LEVEL governs the volume level of the SPEAKERS OUT
A outputs (18). SPK B+C LEVEL allows you to set the volume for
outputs B and C (17)simultaneously.
(6) Use the switches A/B/C ON to switch the speakers A,
B and C on and o.
(7) With the MUTE switch you can disable all loudspeaker and
headphonesoutputs.
(8) The MONO switch switches all monitor paths to mono.
(9) The DIM switch lowers the level of the monitor paths by -20 dB.
This allows you, for example, to talk to somebody while mixing
without losing track of the recording.
(10) Use the TALK LEVEL control to adjust the sensitivity of the
talk-backmicrophone.
(11) The talk-back microphone is installed behind the MIC openings.
Speakinto the microphone to make announcements which
are then routed to the recording devices connected to the
2-TRACK OUT outputs.
(12) The TALK TO CUE/PHONES/SPK A and TALK TO 2-TR OUT
buttons determine where the talk-back microphone signal is
routed to (9).
(13) The switch turns your MINIMON MON800 on and o.
(14) The MON800 is connected to the mains using a 2-pole
POWER connector jack. A matching mains adaptor is
included with the unit.
(15) A second pair of headphones can be connected to the PH jack.
This connector is wired in parallel with the front-panel jack (3).
(16) The TB jack is used to connect a single footswitch (12).
(17) Two pairs of loudspeakers can be connected to the SPEAKERS
OUT B and C jacks.
(18) Connect your main monitor speakers to the SPEAKERS OUT
A jack.
(19) CUE OUT is an additional output, which you can use to route
the MINIMON signals to other devices, such as an additional
headphones amp.
(20) The two 2-TRACK OUT jacks are wired in parallel and carry the
same signals. Use the ¼" or cinch outputs, depending on the
recording device used.
(21) Use the CD/TAPE IN jacks C and D to connect playback devices,
such as a computer, CD/MD or cassette player.
(22) The MIX IN jacks A and B are for connecting the main signal
sources (e.g.mixing console, audio card, etc.) using ¼" plugs.
Mono signals must be connected to the L jacks.
16 MINIMON MON800 17 Quick Start Guide