Behringer U-PHONO UFO202 - 5.2 Hooking up a tape player; 6. Recording Process

11 U-PHONO UFO202 User Manual
3. Connect a monitoring device. You may plug speakers into
the RCA outputs or connect a pair of headphones to the
PHONESoutput.
4. Connect the attached USB cable to a free USB port on
yourcomputer.
5.2 Hooking up a tape player
1. Move the LINE/PHONO switch on the UFO202 to the left
(LINEselected).
2. Connect a stereo RCA cable from the tape player outputs
to the RCA inputs on the UFO202.
3. Connect a monitoring device. You may plug speakers into
the RCA outputs or connect a pair of headphones to the
PHONESoutput.
4. Connect the attached USB cable to a free USB port on
yourcomputer.
6. Recording Process
• After hookups have been made and software installed,
youareready to record the audio. Make sure your audio
recording program is set to record input from the USB
port. Forsimple record, cut, and export of stereo audio,
you may prefer to useAudacity
• If recording from a tape player, make sure the player’s
volume is turned up all the way
• Adjust the input sensitivity of the recording program to
achieve optimal sound quality. Too much signal will cause
the recording to distort; too little signal will sound faint
and thin, so record a test clip to ensure quality sound.
Therecording program should have meters that display
the levels as the audio streams
• Set your recording program on your computer to
RECORD, andbegin playing the start of the tape or record
immediatelyafter
• Let the audio play all the way through the rst side.
Oncethe music stops, press STOP on the recording program
Computer USB
Headphone Out
RCA Outputs
RCA Ins
Line/Phono