BEHRINGER ULTRA-DI DI600P
Technical specifications and appearance subject to change without notice. The information contained herein is correct at the time of printing.
The names of companies, institutions or publications pictured or mentioned and their respective logos are registered trademarks of their
respective owners. Their use neither constitutes a claim of the trademarks by BEHRINGER
®
nor affiliation of the trademark owners with
BEHRINGER
®
. BEHRINGER
®
accepts no liability for any loss which may be suffered by any person who relies either wholly or in part upon
any description, photograph or statement contained herein. Colours and specification may vary slightly from product. Products are sold
through our authorised dealers only. Distributors and dealers are not agents of BEHRINGER
®
and have absolutely no authority to bind
BEHRINGER
®
by any express or implied undertaking or representation. No part of this manual may be reproduced or transmitted in any form
or by any means, electronic or mechanical, including photocopying and recording of any kind, for any purpose, without the express written
permission of BEHRINGER Spezielle Studiotechnik GmbH. BEHRINGER
®
is a registered trademark.
ALL RIGHTS RESERVED © 2006 BEHRINGER Spezielle Studiotechnik GmbH, Hanns-Martin-Schleyer-Str. 36-38,
47877 Willich-Münchheide II, Germany. Tel. +49 2154 9206 0, Fax +49 2154 9206 4603
+ Before connecting to a loudspeaker connector, please
make sure that the GROUND LIFT switch is in LIFT
position (no ground connection). This prevents
accidental shorting of the amp output. Besides, the
tip of the input connector should be connected to the
speaker connector marked with red. The metal casing
of the DI600P should in no case have physical contact
to other equipment.
3. SPECIFICATIONS
Frequency response 40 Hz (-3 dB) to 20 kHz
THD+N (distortion) 0.003% @ 1 kHz,
input level +4 dBu
INPUT ¼" TS (unbalanced)
Level change
(input ß output) -20 dB
OUTPUT Balanced XLR
Impedance ratio
(input ß output) 110 : 1
INST/AMP switch 30 dB pad
FILTER switch Low pass @ 7.5 kHz (-3 dB)
Dimensions (H x W x D) 1.4" x 5" x 3.75"
(35 mm x 128 mm x 95 mm)
Weight approx. 0.66 lbs (0.3 kg)
BEHRINGER continuously strives to assure the highest quality standards
possible. Required modifications may be implemented without prior
notice. Technical data and the appearance of the unit may deviate from
the above values and/or illustrations.
4. WARRANTY
For our current warranty terms, please refer to our website at
http://www.behringer.com
SAFETY INSTRUCTIONS
1) Read these instructions.
2) Keep these instructions.
3) Heed all warnings.
4) Follow all instructions.
5) Do not use this apparatus near water.
6) Clean only with dry cloth.
7) Install in accordance with the manufacturers instructions.
8) Only use attachments/accessories specified by the
manufacturer.
9) Refer all servicing to qualified service personnel. Servicing is
required when the apparatus has been damaged in any way.
To Previous Page
Loading...
