17. Use the balanced DIRECT OUTPUT (XLR) to route the audio signal from your BXD3000H to the input on a
mixing console.
18. Connect your BXD3000H to an external speaker using a speaker cable connected to the SPEAKER OUTPUT
jack.
19. Connect the SEND jack to the input on your effects device. Connect the output on the effects device to the
RETURN jack on the BXD3000H.
20. The CD IN jacks (RCA) allow you to connect an external stereo signal. For example, you can play along with
music from a CD or MP3 player.
21. Send your signal (before the power amp stage) via the LINE OUT jack with a ¼” mono cable (unbalanced).
22. Connect the included footswitch to the FOOTSW(ITCH) jack to switch between channels and
activate/deactivate the ULTRABASS function.
ULTRABASS BXD3000H Getting started
Step 3: Getting started
1. Make sure the amplifier is powered down. Connect the BXD3000H SPEAKER OUTPUT to an external speaker
using a ¼” speaker cable. Do not use an instrument cable to connect the BXD3000H with an external speaker.
2. Plug your bass guitar into the INPUT JACK using an instrument cable.
3. Set GAIN 1 and LEVEL all the way down, MASTER at the 9 o’clock position.
4. Power up the amplifier by pressing the POWER button.
5. Rotate the GAIN 1 knob clockwise while playing until you achieve a satisfactory volume.
To Next Page
Loading...
