TIP regarding “Data” check boxes:
Under “Synchronizing,” check …
o only “Current Set” if you wish to edit the running preset only
o “Current Set” + “Internal Presets” if you want to load the DCX2496 internal
memory bank to the remote software as well
o all three check boxes (including “Card Presets”) if you want to dump the
card presets to your computer as well
o ATTENTION: If you select “Card Presets” and there is no formatted
PCMCIA card inside your DCX2496, you will get an error message if you
try synchronizing
b) PC > DCX2496 #1 > DCX2496 #2
- Make the connections and presets as explained above or in the examples 3
and 4 (see below).
- Power up all DCX2496s and the PC
- Launch Remote Software
- Go to “Connect” Page
- (Click “? Search DCX2496s” only if the devices were not recognized
automatically)
- Please re-name all devices for better overview
- In the left white field, select the DCX2496 device that you wish to edit
- Select under “Synchronizing”: DCX2496->PC / Current Set (/Internal Presets
/ Card Presets)
- Click “Synchronize”
- Select “Stay Synchronized”
- “Return” to the main editor and start editing
- WARNING!: If you made a parameter change on the DCX2496 hardware,
please click on “Quick Synchronize To DCX” to get the change also
transmitted and shown in your editor software!
9
To Next Page
Loading...
