o When the synchronization is complete, hit “Return” to go back to the
main editor program.
---------------
o HINT: Normally you should stay in “Direction: DCX2496 -> PC” mode
and select “Stay Synchronized.” This way, you can edit from your
computer and also in the hardware. More about this subject can be found
in the remote editor software’s help file (press F1 on your PC while the
remote software is running).
ATTENTION: While the software is running, if you switch to another editor
page (for example from XOVER to EQ), the corresponding editor page on
the DCX LCD display WILL NOT be updated! However, making edits (all
changes you make with the mouse or the keyboard) WILL be updated on
the DCX2496 hardware! To check if the data was updated, manually select
the desired LCD screen on the DCX2496 in which you are currently
editing.
Quick info about standard handling
a) PC > DCX2496
- Make the connections and pre-settings as explained above or in the examples
1 and 2 (see below).
- Power up the DCX2496 and the PC
- Start Remote Software
- Go to “Connect” Page
- (Push “? Search DCX2496s” only if your DCX2496s were not recognized
automatically)
- Under “Synchronizing”: Select DCX2496->PC / Current Set (/Internal Presets
/ Card Presets)
- Click “Synchronize”
- Activate “Stay Synchronized”
- “Return” to the main editor and start editing
- WARNING! If you made a parameter change on the DCX2496 hardware,
please click on “Quick Synchronize To DCX” to get the change
transmitted and shown in your editor software!
8
To Next Page
Loading...
