Behringer Xenyx QX1622USB - Mixer Controls Overview; Control Descriptions

12 13XENYX QX2222USB/QX1622USB Quick Start Guide
XENYX QX2222USB/QX1622USB Controls
(EN) Step 2: Controls
(14)
(16)
(18)
(20)
(19)
(17)
(15)
(13)
(10) (11) (12)
(21) (22)
(1)
(2)
(3)
(6)
(7)
(8)
(4)
(5)
(9)
(1) USB wireless input accepts a USB
receiver for use with BEHRINGER ULM
wirelessmicrophones.
(2) GAIN knob adjusts the sensitivity of the MIC
and/or LINE inputs.
(3) COMP knob adjusts the amount of
compression eect on thechannel.
(4) EQ knobs adjust the high, mid and low
frequencies of the channel. Adjust the FREQ
knob to select the specic frequency adjusted
by the MID knob.
(5) AUX knobs adjust how much of the channel’s
signal routes to the AUX SEND jacks.
Pressthe PRE button when routing the
signal to astage monitor. Use the FX knob
to send the channel’s signal to the internal
multi-FXprocessor.
(6) PAN/BAL knob positions the channel in the
stereo eld.
(7) MUTE button mutes thechannel.
(8) CLIP LED lights when the channel
signaloverloads.
(9) CHANNEL FADER adjusts the channel volume.
(10) AC IN accepts the included power cable for
connection to a mains outlet.
(11) POWER ON switch turns the mixer on and o.
(12) PHANTOM ON switch sends 48 V to the XLR
inputs for use with condenser microphones.
(13) MULTI-FX PROCESSOR adds a selected sound
eect to any channels whose FX knob is
turned up. See the Multi-FX Processor section
for details.
(14) AUX SENDS adjust the amount of signal
sent to a monitor speaker or external eects
processor via the AUXSEND jacks.
(15) AUX RETURNS adjust the amount of signal
returning from an external eects processor
that is included in the main mix. Use the
TOAUXSEND knob(s) toinclude the eects
signal in your monitor mix as well.
(16) SOURCE buttons route the USB/2-TR, SUB,
and MAINMIX to the PHONES and CONTROL
ROOM jacks.
(17) USB/2-TR TO MAIN button routes the
USBand 2-TRACK signal to the MAIN MIX.
(18) PHONES/CTRL ROOM knob adjusts the
headphone or studio monitor volume.
(19) VU METER displays the MAINOUTPUT
signallevel.
(20) MODE button determines whether
the channel’s SOLO button operates as
‘Solo in Place’ (button out) or‘Pre-Fader
Listen’ (button in). PFLis preferred for gain
settingpurposes.
(21) SUB faders adjust the output of the
SUBOUTPUT jacks. Use the LEFT/RIGHT
buttons to assign the SUB signal to the left
and/or right MAIN MIX.
(22) MAIN MIX faders adjust the overall output of
the mixer.