Belkin PRO - PS;2 Mouse Problems; Serial Mouse Output Problems

En
SCAN TIME:
Amount of time the OmniView
™
PRO stays
on one port before switching to the next
port when in Scan Mode.
DISPLAY TIME:
Amount of time the OSD Menu or Port
Name remains displayed on-screen after
making a port selection.
Note: If there are slave units present, the SCAN TIME and DISPLAY TIME settings are
set on the MASTER unit only, and need not be set on the slave units.
The BANK/SCAN Button:
Pressing the BANK/SCAN button cycles you through all of the active BANKs (if
there are slave units present) and then puts the unit into AutoScan mode. If the
unit is a single MASTER unit, pressing the button immediately invokes AutoScan
mode. This is evident by a long BEEP, followed by two short beeps.
[↕]: SELECT
(INS): RENAME
(Enter):COMPLETE
(Esc): Exit
SCAN TIME:
■ 7sec ■ 15sec ■ 30sec ■ 60sec
DISPLAY TIME:
■ 7sec ■ 15sec ■ 30sec ■
60sec
[↕]: SELECT
(INS): RENAME
(Enter):COMPLETE
(Esc): Exit
SCAN TIME:
■ 7sec ■ 15sec ■ 30sec ■ 60sec
DISPLAY TIME:
■ 7sec ■ 15sec ■ 30sec ■
60sec
15
Usage (continued)
F1D116_OSD_AM_man.qxd 4/20/00 4:07 PM Page 15