Belkin Wireless G Plus MIMO Router F5D9230-4 - Manually Configuring Network Settings

88
Manually Configuring Network Settings
Set up the computer that is connected to the cable or DSL modem FIRST using these
steps. You can also use these steps to add computers to your Router after the Router
has been set up to connect to the Internet.
Manually Configuring Network Settings in Mac OS up to 9.x
1.
Pull down the Apple menu. Select “Control Panels” and
select “TCP/IP”.
2.
You will see the TCP/IP control panel. Select “Ethernet Built-In” or
“Ethernet” in the “Connect via:” drop-down menu
(1)
.
(2)
(2)
(1)
(1)
3.
Next to “Configure”
(2)
, if “Manually” is selected, your Router will need to be
set up for a static IP connection type. Write the address information in the
table below. You will need to enter this information into the Router.