5554
Using the Web-Based Advanced User Interface
section
1
9
2
3
4
5
6
7
8
10
WEP Setup
64-Bit WEP Encryption
1.
Select “64-bit WEP” from the “Security” menu’s
“Security Mode”.
2. After selecting your WEP encryption mode, you can enter your
key by typing in the hex key manually, or you can put a check
mark in “Passphrase”, then type in your passphrase. Click
“Generate” to generate four different hex keys.
A hex (hexadecimal) key is a combination of numbers and letters
from A–F and 0–9. For 64-bit WEP, you need to enter 10
hex keys.
For instance: AF 0F 4B C3 D4 = 64-bit WEP key
3.
Click “Apply Changes” to save the setting.
WARNING: If you are configuring the Wireless G Router or access
point from a computer with a wireless client, you will need to ensure
that security is turned ON for this wireless client. If this is not done,
your client will lose its wireless connection.
To Next Page
Loading...
