128-Bit WEP Encryption
Note to Mac users:
The passphrase option will not operate with
Apple AirPort. To configure encryption for your Mac computer, set the
encryption using the manual method described in the next section.
1. Select “128-bit WEP” from the “Security” menu’s “Security Mode”.
2. After selecting your WEP encryption mode, you can enter your key
by typing in the hex key manually, or you can put a check mark in
“Passphrase”, then type in your passphrase. Click “Generate” to
generate the hex keys.
A hex (hexadecimal) key is a combination of numbers and
letters from A–F and 0–9. For 128-bit WEP, you need to enter
26 hex keys.
For instance: C3 03 0F AF 0F 4B B2 C3 D4 4B C3 D4 E7 = 128-bit
WEP ke
y
3.
Click “Apply Changes” to save the setting.
WARNING: If you are configuring the Wireless G Router or access point
from a computer with a wireless client, you will need to ensure that
security is turned on for this wireless client. If this is not done, your
client will lose its wireless connection.
To Next Page
Loading...
