Need help?Do you have a question about the Bell and Howell 365 AUTOLOAD SUPER 8 and is the answer not in the manual?
General| Brand | Bell and Howell |
|---|---|
| Model | 365 AUTOLOAD SUPER 8 |
| Category | Projector |
| Language | English |
Instructions for removing the cover and positioning reel arms for operation.
Steps for attaching the take-up reel to the rear spindle.
How to connect the power cord to a wall outlet.
Place the projector on a stable surface aimed directly at the screen.
Turn on the lamp and adjust focus and screen positioning.
Prepare the film leader by cutting and curling it for threading.
Guide film into the slot, engage motor, and start forward motion.
Adjust the lens to achieve a sharp image on the screen.
Adjust the picture position vertically using the Framer Dial.
Stop the film on a single frame for paused viewing.
Engage reverse motion for special effects or scene review.
Steps to stop the projector, rewind film, and store components.
Guide film out of the threading system and projector components.
Steps to manually remove film if automatic threading fails.
Procedure to restore a lost film loop during operation.
Steps for safely replacing a burnt-out projector lamp.
General advice on projector maintenance.
Instructions for cleaning the projector's aperture and film path.
Steps for removing and cleaning the projector lens.
To Next Page
