Need help?Do you have a question about the Belle X Series and is the answer not in the manual?
General| Brand | Belle |
|---|---|
| Model | X Series |
| Category | Security System |
| Language | English |
Plug in the charging cradle and place Belle into the cradle as shown.
Typical charging time is 2-3 hours; light indicates charging status.
Battery life varies; device announces 'Battery low' when pressing call button.
Identifies speaker, call button, and microphones on the Belle device.
Explains red light behavior during charging and low battery states.
Describes the solid blue light indication during an SOS call.
Press and hold the call button until the light turns blue to initiate a call.
Contact dealer if Belle does not connect properly.
Press and hold call button until blue light; speak to specialist during test.
Contact dealer immediately if the device does not test properly.
Steps to remove lanyard and attach the belt clip to the device.
Use a soft cloth to clean gold contacts on device and cradle for proper charging.
Household cleaner can be sprayed onto the cloth, not directly on the device.
Adequate cellular coverage is required; test device in your area.
Wear device always; charge only when necessary; follow procedures for proper function.
Belle is IPX7 water-resistant; do not submerge; towel dry after exposure.
Consult physician regarding pacemaker interaction with cell phones.
Optional service using algorithms to detect falls and connect to specialists.
Uses technology to determine physical location for monitoring purposes.
Authorizes collection and sharing of location data for monitoring services.
Device complies with Part 15; may not cause harmful interference and must accept interference.
Unauthorized modifications void user's authority to operate the equipment.
Equipment tested and complies with limits for reasonable protection against interference.
Measures to correct interference: reorient antenna, increase separation, change circuit, consult technician.
Device contains licence-exempt transmitters/receivers complying with Canada's RSS.
Device must not cause interference and must accept any interference.
Provides manufacturer name, website, and support email address.
To Next Page