Page 2 19-461’02 Rev. D September 2017 RFM300-T
Declaration of conformity
According to ISO/IEC 17050-1 & 2: 2004
Manufacturer's Name Bellingham + Stanley
Manufacturer's Address Longfield Road,
Tunbridge Wells,
Kent TN2 3EY
United Kingdom
declares that the product
Product Name RFM300-T Series Refractometer
Model Number All
Is designed to conform to the following Product Specifications:
Safety:
BS EN 60950-1:2002
Applied and met EMC test standards:
Emissions
EN 61326-1:2013
• Radiated emissions CISPR 11:2009 inc.
A1:2010, Class A
• Conducted emissions, ac port CISPR 11:2009 inc.
A1:2010, Class A
• Conducted emissions, ethernet port CISPR 11:2009 inc.
A1:2010, Class A
EN 61000-3-2:2014
• Mains harmonics Class A
EN 61000-3-3:2013
• Mains voltage flicker (dmax=4%)
Immunity:
EN 61326-1:2013 - Basic immunity requirement (Table 1)
• Electrostatic discharge EN 61000-4-2:2009
• Radiated RF interference EN 61000-4-3:2006 inc.
A1:2008 & A2:2010
• Fast transient bursts EN 61000-4-4:2012
• Surge EN 61000-4-5:2014
• Conducted immunity EN 61000-4-6:2014
• Voltage dips and interruptions EN 61000-4-11:2004
Supplementary:
The product herewith is designed to comply with the requirements of the EMC
Directive 2014/30/EU and the Low Voltage Directive 2014/35/EU.
This symbol is an internationally agreed indicator that the
product bearing it should not be disposed of as general
waste or garbage which might end up in landfill sites, but
should instead be sent for special processing and/or
recycling in those countries where appropriate legislation
and facilities are in place.
The symbols below are used throughout this user guide.
Caution or warning.
Electrical hazard.
Hint or tip.
To Next Page
Loading...