Bellini BTSSC70 - Compulsory Warning

3
•
Do not place anything, other than the
tempered glass lid
, on top of the Slow Cooker
when assembled, when in use and when
stored.
•
Always turn the Temperature Control Dial to
the ’Off’ position, switch off at the power outlet,
unplug the power cord from the power outlet,
remove the connector end of the power cord
from the appliance and allow the appliance to
cool, if appliance is not in use, before cleaning,
before attempting to move the
appliance,
dissembling, assembling and when storing the
appliance.
•
Keep the Slow Cooker clean. Follow the
cleaning instructions provided in this book.
•
Unwind the power cord fully before use.
•
Do not let the power cord hang over the edge
of a bench or table, touch hot surfaces, or
become knotted.
•
To protect against electric shock, do not
immerse power cord, plug or stainless steel
housing in water or any other liquid.
•
This appliance is not intended for use by
persons (including children) with reduced
physical, sensory or mental capabilities, or
lack of experience and knowledge, unless they
have been given supervision or instruction
concerning use of the appliance by a person
responsible for their safety.
•
Children should be supervised to ensure that
they do not play with the appliance.
•
This appliance is for household use only.
Do not use this appliance for anything other
than its intended use. Do not use in moving
vehicles or boats. Do not use outdoors. Misuse
may cause injury.
•
It is recommended to inspect the appliance
regularly. Do not use the appliance if the
power cord, power plug or appliance becomes
damaged in anyway. Return the entire
appliance to the nearest authorised Bellini
Service Centre for examination and/or repair.
•
Any maintenance other than cleaning should
be performed at an authorised Bellini Service
Centre.
•
The installation of a residual current device
(safety switch) is recommended to provide
additional safety protection when using
electrical appliances.
Compulsory Warning
If the supply cord is damaged, the cord must be
replaced by the manufacturer, its service agent
or similarly qualifi ed persons in order to avoid a
hazard
.
This product has not been designed for any uses
other than those specified in this booklet.
Save These Instructions