Bellman Audio Maxi BE2020

To Next Page

For use in all EU countries

Hereby, Bellman & Symfon AB, declares that this BE2020 is in compliance with the

essential requirements and other relevant provisions of

directives: EMC 1989/336/EC.

Correct use and disposal of batteries:

Replace only with the same or equivalent type recommended by the manufacturer.

Please dispose of old, defective batteries in an environmentally friendly manner in

accordance with the relevant legislation.

Maxi

Personal ampliﬁer

For a complete Declaration of Conformity please contact info@bellman.se or call +46 31 68 28 20

Need help?

Do you have a question about the Bellman Audio Maxi BE2020 and is the answer not in the manual?

Summary

Getting started

Unpacking, installing and testing the unit

Steps for unpacking, inserting batteries, connecting accessories, and initial testing of the Maxi device.

Function

Built-in microphone

Details the location and omnidirectional nature of the device's internal microphone.

Telecoil

Explains the telecoil's position and use in environments with inductive loops.

Selecting the signal source

Describes manual selection between internal microphone and telecoil.

External sound source

Covers connecting external audio devices via a 2.5mm jack.

Combined signal sources

Explains how to combine external sound with the internal microphone.

Indicators and settings

Volume and Tone LED Indicator

Explains the LED indicator for volume and tone controls.

Low battery LED

Explains the low battery indicator and battery replacement procedure.

Volume control

Details how to adjust the volume using the device's control buttons.

Tone control

Details how to adjust the tone (treble) using the device's control buttons.

Troubleshooting