.
15
14
1. INSTALLATION
ON / OFF
STABILIZE
THE SPA
FILLING IN
WATER
2.
3.
4.
• Check and make sure there is no damage on power cord and the product when
you open the package case.
• The spa comes with 4 wheels. Two of them have brakes, insert these two in the
holes on the bottom of spa near the drain pipe. The other two shall be inserted
in opposite side.
• To install the wheels, simply push the metal stick into the holes in the bottom
of spa corners directly.
• Place the spa on flat and dry floor where you want to use.
• Make sure the 4 wheels on the bottom of the spa are stabilized so that the spa
will not move around during use.
• Make sure you are seated on a chair or sofa before starting.
• Do not plug in power cord to an outlet now.
• Press ON/OFF button once to turn on power, the two-digit LED display
immediately shows the current water temperature inside water container.
• The default spa massage time is 30 minutes once the power is turned on. You
can use TIMER to increase spa massage time. ( up to 60 Minutes)
• The default maximum water heating temperature is 95°F once the power is
turned on.
• HEATING Function is ON automatically if the current water temperature is
lower than its default 95°F.
• Plug in power cord to the power outlet.
• You must fill in water before turning on the foot spa. Never try to operate this
spa without water in the bucket.
• Filling in water with a water bucket or a clean pot. Do not have your spa under
faucet directly to fill water.
• Be careful NOT to spill water on the control panel.
• To speed up water heating, you can fill in warm water but the warm water
temperature shall be lower than 113°F.
WATER LEVEL:
• It is recommended to fill in water up to 50%-60% (just about over half full) of
the entire bucket.
• The maximum water level is 70% of the water container.
5. HEATING
TEMP + / -6.
AUTOMATIC WATER TEMPERATURE BALANCING SYSTEM:
• The default maximum water heating temperature is 95°F once the power is
turned on.
• If the just-filled-in water temperature is lower than 95°F, the heating function
will be turned on automatically and stopped when its water temperature
reaches 95°F.
• Heating function will be turned on automatically and stopped when its water
reaches 95°F. When its water temperature cools down below 95°F, the heating
function will be turned on automatically again, and so on.
• When the water temperature reaches its default maximum temperature of
95°F, the KEEP WARM function takes effect.
Note: The heating function will not be on if your fill-in water temperature is
already higher than its default maximum 95°F.
• If you prefer to change its default maximum water temperature to be higher
than 95°F, you can press the TEMP + / TEMP - to reset the maximum water
heating temperature.
• The highest heating temperature you can set is 118.4°F.
• The lowest heating temperature you can set is 95°F.
WHEN TO USE TEMP (+/-) :
• The Temp +/- button can be used to change maximum water heating
temperature under any massage modes.
• Press TEMP+/- to increase water heating temperature you want (such as 107.6°F).
After 3 seconds, your just-set temperature will disappear from LED screen, and
its LED display will switch back to show its current water temperature.
• Press TEMP+/- to decrease water heating temperature (such as 96.8°F). After 3
seconds, your just-set temperature will disappear from LED screen, and its LED
display will switch back to show its current water temperature.
• To protect the heating spa, it is recommended NOT to set the temperature to
the maximum level (118.4°F).
To Next Page
Loading...