HOW TO USE?
PROCESS CHART
benbow.de
CLASSIC FOAM GUN
Pour the active foam concentrate and water into the foam gun tank in
the correct proportions, then securely screw the tank onto the foam gun
Aim the nozzle at the surface to be cleaned, open the chemical flow from
the tank, and press the trigger.
Apply the foam in vertical strips, starting from the bottom and working
upwards. After letting the foam sit for a few minutes, rinse the entire
surface thoroughly.
Connect the foam gun to a compressor with suitable parameters
3
1
4
IMPORTANT
After use, flush the device with clean water to maintain its performance
The foam density depends on the concentrate and the proportions used
Most active foams must be rinsed off completely and should not be allowed to dry on the surface
The foam gun can be used for cleaning cars, bicycles, agricultural machinery, and industrial
equipment
The foam should not be excessively thick; it should flow slowly down the surface for optimal
cleaning
2
EN
To Next Page
Loading...