73
• The laser scanner of the CD player can ingress humidity when:
• the set-up position is quickly changed from a cold area to a warm area
• a heating unit is suddenly turned on
• the unit is set-up in a differently acclimatised room.
Malfunctions can occur if there is a build-up of condensation within the device. In this case the
device should not be used for several hours until normal playing is once again possible.
POWER SUPPLY
When using the device in mains supply operation it is imperative that you comply with all techni-
cal data and instructions found in the operating manual and those on the device.
• Caution! Use only the mains cable supplied with the device otherwise there is a danger of
fi re and/or electrical shocks!
• When disconnecting from the mains, be sure to grip the plug when pulling out from the
socket and never pull out by gripping the cable.
• Never handle the mains cable and/or the plug with damp or wet hands because of the danger
of electrical shocks!
• Handle electrical cables with care; do not buckle or crimp the cable. Cables should not be
laid on the fl oor in such a way it is possible to step on them. Please be especially careful with
the mains cable between the electrical socket and the device.
• Using cables and plugs which do not correspond to the stipulated voltage can result in fi re and/or
electrical shocks. If the equipment is not going to be used for a long period of time, it should be
unplugged from the mains power supply and the batteries removed. The device is still electrically
live even if it has been turned off but the plug is still in the mains supply socket.
OPERATING ELEMENTS AND DISPLAY FUNCTION
1. Loudspeakers
2. CD compartment
3. OPEN/CLOSE button Opens/closes the CD compartment
4. STANDBY Switches the appliance on/puts the appliance
on standby mode
5. EQ button Selects the equaliser curves
6. CD button Activates the CD player
7. TUNER button Activates the radio
8. AUX button Activates the aux. mode
9. Phones Headphones connection
10. VOLUME +/— buttons Controls the volume
11. POWER button Switches the system on/off
12. Signal receiver for remote control
13. LCD display
14. INTRO button Activates the preview function
15. MIX button Activates the random play function
16. PLAY/PAUSE button Starts playing/pauses CD
17. BAND button Selects AM/FM waveband
18. MEMO/PROGRAM button Activates the programming function
19. MEMO-UP/REPEAT button Repeats individual/all CD tracks
20. TUNING/SKIP/SEARCH +/— buttons When used with CD player: skips to the begin
ning of the next track/to the beginning of the
track which is currently playing or forward/
reverse search; When used with the tuner:
automatic tuning
21. STOP button Stops playing the CD
Remote control
1. POWER button
2. MUTE button
3. EQ button
OPERATING INSTRUCTIONS
To Next Page
Loading...