1
Crisscross Contents:
Pictured items in bold
Quantity Description
2 Crisscross arms
1 pivot pin
3 snap rings (one extra)
2 8” mounting pins (Solo only)
2 2-1/2” mounting pins (Retro only)
2 iron mounting brackets (Retro only)
4 5/16” x 1-1/4” cap screws (Retro only)
2 1-3/4” steel bearing plates
2 #8 wood screws
ATTENTION!
Read and understand these instructions COMPLETELY AND THOROUGHLY
before starting the installation or cutting into your bench. This includes instal-
lation of both Crisscross Solo and Retro, and the Troubleshooting sections.
We highly recommend that you NOT begin installation without the Crisscross
and all vise hardware in your possession.
AAsssseemmbbllyy && IInnssttaallllaattiioonn IInnssttrruuccttiioonnss FFoorr::
BBeenncchhccrraafftteedd CCrriissssccrroossss SSoolloo && RReettrroo
Install a Crisscross with any leg vise hardware, begin here
oo rr
Unpacking your Crisscross:
Some parts are heavy. Be careful as you unpack and handle them. Also be aware that although we make
every effort to ease all edges, being cast and machined parts you may encounter a sharp egde or burr. If
you do, ease it with some fine abrasive paper or a fine file. Some components may have a rust prevent
tive oil applied. You may want to remove this oil before installing the vise. Wipe it off with a paper towel.
This will leave a light film of oil on the parts that will help prevent rust and keep the parts moving smoothly.
CCrriissssccrroossss
SS oolloo
CCrriissssccrroossss
RR eettrr oo
BBeenncchhccrraafftteedd GGlliiddee MM && GGlliiddee CC
Install a Glide M or Glide C, begin on page 12
Copyright, Benchcrafted 2017 Version: March 2017
To Next Page
Need help?
General
