12
Before leaving the driving seat:
1. Place the gear shift in neutral “N” and engage the parking brake.
2. Disengage the blade and lower the blade deck.
3. Stop the engine and remove the key.
Before carrying out any inspection, cleaning, and servicing
operations on the machine or before unblocking the grass unloading pipe, stop the
engine, take out the ignition key and follow the instructions in the operator’s manual.
The blades are sharp, risk of a serious injury!
Before carrying out any inspection, cleaning, and repair operations on the cutting
parts, stop the engine and take out the ignition key. Next, disconnect the spark plug
wire and keep the cap away from the plug to prevent accidental starting.
The blades are sharp, risk of a serious injury!
1. Wait for the blade and all the moving parts to come to a halt before touching
them. The blade will continue turning for some time after switching off the engine
or disabling the blade control.
2. Disengage the blade during transport and every time it is not used.
Stop the engine, remove the key, and disengage the blade:
1. Before leaving the machine.
2. Before filling up with petrol.
3. Before removing the grass bag.
4. Before adjusting the cutting height if the operation is not performed from the
driving seat.
Make sure the accelerator is set at a minimum before switching off the engine.
Stop the engine, remove the key, and disconnect the spark plug wire:
1. If you knock against a foreign body, stop the engine, disconnect the spark plug
wire, and carefully inspect the lawn mower for any damage.
2. Have any damage repaired before you start the engine again. Use the services of
an authorized service center. Should the machine display unusual vibrations,
stop the engine, and immediately seek the cause of the vibrations, as a rule,
unusual vibrations are an indication of a problem.
To Next Page
Loading...
Need help?
General
