95
Electrical equipment
9
GENERAL INFORMATION
ELECTRICAL PANEL
The electrical switchboard does not require any routine maintenance
.
In case an electric appliance is not energized, check:
- The main power supply (batteries, battery switches).
- The switches and circuit breakers on the line.
- the relevant electrical unit.
The fuel guage can be read by pressing the switch.
ELECTRICAL CIRCUIT, 12 V
GENERAL RECOMMENDATIONS
- Never work on a live electric fitting.
- The batteries must be strongly fastened.
- Do not block the battery ventilation ducts, some of them may give off hydrogen which represents a danger of
explosion.
- The batteries must be handled with care. In the case of contact with electrolyte thoroughly rinse off the affected part
of the body and consult a doctor.
- To avoid short-circuiting between the battery poles do not store conducting objects near to the batteries (metal tools,
etc...).
- Turn off the electrical circuit with the battery switches when installing batteries or during their connection/
disconnection.
- Never modify the specifications of power overload protection devices.
- Never modify an installation. Use the services of a qualified marine electricity technician.
- Never install or replace the electric appliances (or any electric equipement) by components exceeding the capacity
(amperage) of the circuit (Watt for bulbs).
- Do not leave the vessel unattended when the electrical system is switched on .
WARNING
-Handle the batteries with care (Please refer to
the manufacturer's instructions.
-In case of electrolyte splashing, thoroughly rinse
the part of the body that has been in conctact
with it. Obtain medical advice.
PIECE OF ADVICE -
RECOMMENDATION
-Keep the batteries clean and dry in order to
avoid premature wear.
-Periodically check the electrolyte level. Add
distilled water when needed.
-Tighten and maintain the terminal connectors
by greasing them regularly.
-Disconnect the batteries during winter storage
or long periods of inactivity.
To Next Page