PHOT
DAS
P.P. PED
N.C. inputs are represented by the vertical segments. N.O. inputs are represented by the horizontal segments.
REMOTE COPY OF TRANSMITTER CODES
If a transmitter code is already stored in the receiver, the radio remote copy can be carried out (without accessing to the control unit).
IMPORTANT: This procedure should be performed with gate leaves open, during the TCA dwell time. Proceed as follows:
1 Press the hidden key of the already memorised transmitter.
2 Within 5 seconds, press the key of the already memorised transmitter which corresponds to the channel to be matched with the new
transmitter code. The flashing light switches on.
3 Within 10 sec, press the hidden key of the new transmitter.
4 Within 5 sec, press the key of the new transmitter to be matched to the channel selected at point 2. The flashing light switches off.
5 The receiver memorises the new transmitter and exits immediately the programming mode.
ERROR MESSAGES
The control unit checks the correct operation of the safety devices. In the event of faults the following messages can be displayed:
Err1
Motor Technical assistance is required.
Err4
Error, PHOT O circuit check Check connections, alignment of PHOT O photocell or obstacle present.
Err5
Error, PHOT C circuit check Check connections, alignment of PHOT C photocell or obstacle present.
ENC
Error, encoder Error to connection or faulty encoder.
Amp
Obstacle detection An obstacle present is indicated (anti-crash device).
FUSES
F1 Protection fuse for motor and blinker
F2 Protection fuse of accessories and signals
F3 Protection of 230V/115V line
WASTE DISPOSAL
If the product must be dismantled, it must be disposed according to regulations in force regarding the differentiated waste disposal and
the recycling of components (metals, plastics, electric cables, etc..). For this operation it is advisable to call your installer or a specialised
company.
To Next Page
Loading...
