5
USING THE FILTER & FILTER DRAWER
• Use the Filter Drawer Tab (5) to pull out the Filter Drawer (fig. A)
• Remove the Filter by lifting it up and out of the Filter Drawer (fig. B).
Fig. A Fig. B
Fig. C
• For best cooling results, lightly pre-soak the Filter under cold, running water (fig. C).
After pre-soaking, ensure to wipe off any excess and dripping water from the Filter
• For increased cooling power, place the wet Filter into your freezer for a couple
of minutes, then replace the frozen Filter back in the Filter Drawer of your
Personal Air Cooler before use
• Place the Filter back into the Filter Drawer Slot by positioning it above the Filter
positioning guides and sliding the Filter down into place
• Close the Filter Drawer by pushing it back into the appliance
To Next Page
Loading...