E. Flash WB & Light/Slow Calibration
1. Put the camera on the fixture and press “Tele+Set+Playback” to access the test mode
2. The on screen display shows “Flash WB” message (Fig. 15). Shoot the subject which is located 2 M distance in low-light
environment.
3. Tap “OK” button and press “Set” button, the test program will execute automatically.
4. The on screen display shows “OK (Fig. 16) once the test is passed. If it shows “NG”, it means the test was failed.
5. The on screen display shows “Light/ S.S” message (Fig. 17). Put the camera in front of light source box around 35 mm.
6. Tap “OK” button and press “Set” button, the test program will execute automatically.
7. The on screen display shows “OK (Fig. 18) once the test is passed. If it shows “NG”, it means the test was failed.
- -
.
Fig. 15 Fig. 16
To Next Page
Loading...
Need help?
General
