INTRODUCTION
This is a guide on how to upcycle a Beovox RL6000 loudspeaker using
a BeoCreate 4-Channel amplifier and a Raspberry Pi.
The upcycling process will take roughly two hours and we advise you
to prepare for the project by having all the required items at hand.
PARTS
· Beovox RL6000
· BeoCreate 4-Channel Amplifier
· Raspberry Pi 3
· MicroSD card (at least 4GB)
· Power plug & supply (page 3)
·3D printed parts (page 3)
·Two insulated wires for the
power connector (45cm)
TOOLS
·Soldering iron
· Screwdrivers
· Wirecutters
· Wirestripper
· Electric drill
· 8mm drill bit
2
To Next Page
Loading...
General