12
Double induction cooker Use instructions
Error Cause Solution
E0 The cooking container is not suitable
The cooking container is not positioned in
the cooking area
Use a cooking container for induction cooking
and place it in the centre of the cooking area
E1 Error in the internal circuit Contact the after sales service
E2 Internal overheating Use a suitable cooking container
Check that the ventilation fan is not obstructed
If the problem persists, contact the after sales
service
E3/E4 High or low voltage Connect to an electrical network as indicated
on the label on the product
E5 Error or short circuit on the temperature
sensor or other parts
Contact the after sales service
E6 Overheating of the cooking glass Allow to cool and remove the container,
after cooling you can resume cooking
Error messages
Cleaning
Disconnect the plug from the electrical outlet and allow each part to cool before performing any cleaning ope-
rations.
Do not immerse the product in water or other liquids. In any case, prevent water or other liquids from owing
over the cooking surfaces.
Do not use abrasive or metal sponges for cleaning.
Clean the hob with a slightly damp soft sponge.
Technical data
Power: 3500W(2000W+1500W)
Power supply: 220-240V~ 50/60Hz
For any improvement reason, Beper will reserve the right to modify or improve this appliance without
notice.
To Next Page
Loading...
