Rechargeable Table Lamp Use instructions
7
This appliance is for household use only.
To protect against electric shock, do not immerse cord, plug or any
parts of the appliance into water or other uids.
Do not use the appliance near explosives, highly ammable mate-
rials, gases or burning ames.
Do not allow children, disabled people or every
people without experience or technical ability to
use the appliance if they are not properly watched
over. Close supervision is necessary when any ap-
pliance used by or near children.
Usage warnings
The battery is fully recharged in about 5 hours, while the autonomy is about 10 hours at maximum brightness.
At minimum brightness the battery lasts about 15/18 hours.
Do not turn on the lamp while the product is charging.
The product is equipped with an overcharge protection to ensure a longer battery life.
Place the lamp away from rain. Store the lamp in a dry and safe place. The IPX4 protection level protects the
product from splashes of water but not from atmospheric agents.
Product description Fig.A
1. ON/OFF and intensity adjustment touch switch
2. Charging socket
3. USB charging cable
4. Lampshade
5. Shaft
6. Base
Battery charging
Insert the type C plug into the charging socket located under the lampshade. Connect the USB cable to a USB
charging source. It takes about 5 hours for a full charge. Gently unplug the cable from the charging socket.
Instructions for Use
Place the lamp on a at surface. To turn on the product, touch the switch. Touch the switch again to change
the light from warm to cold and natural light. To adjust the intensity of the light, keep the switch pressed until
the desired brightness is reached.
Cleaning
Before cleaning, disconnect the lamp from the power supply.
Clean the product with a dry cloth; do not use solvents or abrasive products.
Technical data
1W, IPX4, 3000K/4500K/6500K, 100/110/113lm
Rechargeable lithium battery 3.7V - 2000 mAh
USB power supply: 5V
With a view to continuous improvement, Beper reserves the right to make changes and improve-
ments to the product in question without prior notice.
To Next Page
Loading...