Beper P205DIF100 - Product Operation and Features; Product Components (Fig. A); Appliance Usage Guide (Fig. B)

EN
9
Warning
The product is protected by the auto power-off function.
After continuously working for 2 hours, the appliance will
switch off automatically. To use the appliance again ple-
ase turn it on after adding more water.
It is advisable to use puried water.
When the mist becomes thinner, please replace the cot-
ton lter as indicated in the paragraph “Cleaning and
maintenance”.
Use water-based fragrance oils, do not use oil-based
fragrances.
This appliance can only be used when the car engine
is on.
Do not use the appliance when there is not enough wa-
ter in the tank.
Keep this appliance out of the reach of children.
When the appliance is not used, disconnect it from the
socket, empty the water tank and store it in a cool, dry
place.
If the appliance does not turn on, make sure that it is
correctly inserted in the cigarette lighter socket; also
check the status of the fuse inside the 12V plug, and
replace it if necessary (see paragraph “Cleaning and
maintenance”).
Description of product Fig. A
1. Atomizer
2. ON/OFF switch
3. Water tank
4. Cotton lter
5. 12V plug
Use of the appliance Fig. B
The product works as air humidier as well as aroma
diffuser.
To ll the tank, remove it by turning it clockwise.
Fill the tank with water and, if needed, a few drops of
fragrance oil, making sure not to overll the tank.
Place the water tank back in position and rotate it
counterclockwise to fasten it tightly.
Connect the plug of the appliance into the cigarette
lighter socket. The appliance enters standby mode.
Touch the ON/OFF switch button once, the appliance
enters humidication mode, with continuous mist.