Beper VE.502 - Page 11

EN
Mist Fan Use instructions
11
12. Carrying tubes
13. Bottom tube
14. Perforated lid
15. Tank
16. Tank closure cap
17. Nebulizer base
18. Nebulizing switch
19. Nebulizer adjustment knob
20. Plastic base
22. Screws with ring for base
Remote control
To make the remote control working, open the rear door and place the batteries (2xAAA not included) by following
the correct polarity, close the door. Follow the same procedure to replace the batteries when they are exhausted.
Head inclination
It is possible to incline the fan head in different positions, allowing you to change the airow inclination.
Turn the fan off before changing the inclination.
Hold the motor unit and incline the fan head in snapshot to the desired position.
Caution: do not force the movement to prevent the mechanism from breaking.
Cleaning
Before performing any cleaning, turn off the fan and disconnect the plug from the power outlet. To clean the
fan, use a soft cloth, possibly dampened with water. Do not use alcohol or chemicals such as diluents, abrasive
products in general.
Empty the tank completely and rinse it in order to avoid the formation of limestone, odor and mold.
Dry all washed / cleaned parts thoroughly before switching on the fan.
Technical data
Power: 75W
Power supply: 220V~ 50Hz
For any improvement reasons, Beper reserves the right to modify or improve the product without any
notice.
The European directive 2011/65/EU on Waste Electrical and Electronic Equipment (WEEE), requires
that old household electrical appliances must not be disposed of in the normal unsorted municipal
waste stream. Old appliances must be collected separately in order to optimize the recovery and
recycling of the materials they contain, and reduce the impact on human health and the environment.
The crossed out “wheeled bin” symbol on the product reminds you of your obligation, that when you
dispose of the appliance, it must be separately collected.