EasyManua.ls Logo

Berner BWDVC Top Permanent - 2 Before use; 3 Indicator and operating elements

Berner BWDVC Top Permanent
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
20 - GB
l WARNING!
Use only the brushes supplied with the vacuum device or

may pose a safety hazard.
Clean and disinfect the vacuum device immediately after use
to prevent microbial contamination due to long-term failure to
clean it, especially when using the device in food-processing.
Do not use any steam jets or high-pressure cleaners for
cleaning.
Acids, acetone and solvents may corrode parts of the vacuum
device.
Do not leave the device without supervision. In case of longer
interruptions of work, pull the power plug.

l DANGER!
Have repairs been made only by experts, e. g. the producer’s
service. Use original spare parts only.
Improperly repaired devices pose a hazard for the user.
2 Before use
When unpacking, check that the delivery is complete and that
there is no transport damage.
Before using, the operators should be provided with information,
instructions and training for the use of the vacuum cleaner
and the substances that it is to be used for, including the safe
procedure for the removal of the gathered material.
3 Indicator and operating elements
Select from the following functions and settings:
0 Vacuum cleaner is switched off - Plug socket current-conducting
I
Vacuum cleaner is running
- Plug socket current-conducting
- Automatic shaker function off
IR
Vacuum cleaner is running
- Plug socket current-conducting
- Automatic shaker function on
AR
Ready for operation
- Plug socket curren-conducting
- Automatic shaker function on
- The vacuum cleaner is switched on and off via the connected electrical/
compressed air tool* at the plug socket.
Automatic shaker function
- 

air.
Fill level indicator *
- When the container is full and/or there is a blockage in the suction hose, the
full indicator lights up. On the M and H vacuum cleaners, an acoustic signal
is also emitted.
Speed regulation * - The suction performance can be regulated using the speed regulator.
Setting the suction hose diameter * - Determine the maximum negative pressure for automatic shaking.
(*depending on the equipment variant of your vacuum cleaner)

Related product manuals