22 - GB
▷ Remove the suction hose from the liquid before emptying.
▷
the hose, as a result of the high suction level and the favourable
▷
NOTE
If you change between dry and wet vacuum cleaning frequently,
6 Permanent lter cleaning
so that continuous working can be guaranteed.
7 Emptying the container
NOTE
Only permitted for dust with AGW‘s > 1mg/m
3
Switch the vacuum cleaner off, pull the mains plug out.
▷ Open the latches.
▷ Remove the cover and suction hose from the container.
▷ Empty the container by pouring out.
7.1 Dispose of the paper lter bag
▷ Pull the mains plug out (see short-form instructions ).
▷ Fit mouth protection.
▷ Remove suction hose, close off the suction spigot with a plug*.
▷ Open the side latches, remove the top section.
▷
▷ Dispose of the vacuumed up material in accordance with legal
requirements.
7.2 Dispose of the PE emptying and disposal bag
▷ PE emptying and disposal bag: Switch the vacuum cleaner on,
(see short-form instructions
).
▷ Fit mouth protection.
▷ Remove suction hose, close off the suction spigot with a plug*.
▷ Open the side latches, remove the top section.
Before setting aside the top section, switch to >IR< position, to
▷ Close off the PE emptying and disposal bag carefully with the
tape provided.
▷
▷ Remove the PE emptying and disposal bag carefully from the
container
▷ Dispose of the vacuumed up material in accordance with legal
requirements.
7.3 Insert paper lter bag
NOTE
▷ (see short-
form instructions
).
NOTE
Operating the rotary slider*
▶ Push the rotary slider* from the inside to the outside, turn
through 180° (see mark) and then push inwards again from
the outside through the suction spigot
▶ Place the rotary slider* in the suction aperture with the mark
(* depending on the equipment variant)
▷ Place the upper section on the container and close the side
latches.
7.4 Insert PE emptying and disposal bag*
NOTE
Only the vacuum cleaners class M and H with special contain-
ers and rotary slider in the suction aperture of types ISP ARM,
ISP ARH and ISP ARH-Asbestos are suitable for the use of PE
Emptying and disposal bags.
NOTE
Operating the rotary slider*
▶ Push the rotary slider* from the inside to the outside, turn
through 180° (see mark) and then push inwards again from
the outside through the suction spigot
▶
pointing upwards.
▷
the upper bag opening over the edge of the container.
To Next Page
Loading...
