8
Mode of operation
Attaching the embroidery hoop
> Hold the embroidery hoop at the at-
taching mechanism and pass under
the presser foot. (8).
> Squeeze the both ends of the atta-
ching mechanism against each other.
> Position the embroidery hoop above
the attaching mechanism and push
down.
> After the embroidery hoop has en-
gaged, release the ends of the atta-
ching mechanism.
Embroidering
> Open the desired embroidery motif
and make the necessary adjustments.
> Start the embroidery process.
Removing the embroidery hoop
> Squeeze both ends of the attaching
mechanism against each other.
> Remove the embroidery hoop.
Finishing and cleaning
> Squeeze both ends of the attaching
mechanism against each other.
> Remove the fabric.
> Remove adhesive residues on the
hoop using cleaning spray if neces-
sary.
en
8
To Next Page
Loading...