EasyManua.ls Logo

Bernzomatic ST500 - CAUTION; Avoid Breathing Vapors; COMPONENTS; ST500 Components Overview

Bernzomatic ST500
4 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
DO NOT DISCARD THESE WARNINGS AND INSTRUCTIONS
200 Old Wilson Bridge Road
Columbus, OH USA 43085
(866) 928-2657
worthingtoncylinders.com | bernzomatic.com
06/24/15
Protective
Cap (L)
• Use caution when operating the torch outdoors on sunny or windy days. Bright sun makes it impossible to see the
torch’s flame. Wind may carry the torch’s heat back towards you or other areas not intended to be heated. Windy
conditions may also cause sparks to be blown into other areas with combustible materials.
• Burner nozzle and tip assembly become extremely hot during use and remain hot after extinguishing the torch. Take
precautions not to touch torch tip until torch has cooled.
• Never use the torch on or near combustibles (fuels, rags, towels, paper products, etc.). Be careful around motor
vehicles or any gasoline-fired products and beware of hidden fuel lines and tanks.
• Always make certain the torch is resting on the stand to reduce the risk of accidental tip over. Be sure the torch is
not pointed in a direction which could cause nearby objects to ignite when the torch is set down.
• Never leave the torch unattended when lit.
• Never attempt to repair or heat a gasoline tank, a chemical drum an aerosol can, a compressed gas container that
held flammable liquid or gas or any other chemical. Heating these is extremely dangerous, especially after they have
been “emptied”.
• Department of Transportation Hazardous Materials Regulations forbids the carriage of butane or other flammable gas
products on passenger aircraft. Do not pack this item or any other flammable gas item in any checked or carry-on
baggage.
• Make sure torch is completely extinguished after use.
• Ensure that torch is completely cool before storing.
CAUTION
Exercise caution when using this device not to breathe vapors. Depending on the task being conducted with device
(wood burning, melting plastic, etc.) toxic or nauseating vapors may exist.
COMPONENTS
Fill Valve (A)
Adjustment Knob (B)
Continuous
Flame Lock (E)
Safety Lock (C)
Locking Nut (F)
Ignition
Switch (D)
Gas Torch Tip (G)
Soldering Tip
Ass'y (H)
Tip (K)
ST500 ST1000
Protective
Cap (L)
Exhaust Port (J)
Fill Valve (A)
Adjustment Knob (B)
Folding Stand
Continuous
Flame Lock (E)
Safety Lock (C)
Locking Nut (F)
Ignition
Switch (D)
Gas Torch Tip (G)
Soldering Tip
Ass'y (H)
Tip (K)
Exhaust Port (J)