How to change speed
WARNING
• Make sure you release the
clutch lever before using the speed
lever.
• Use gears F1 and R when trav-
elling downhill or on a ramp.
• Do not change gear when trav-
elling downhill or on a ramp.
1. Release clutch lever (A).
2. Place speed lever (B) in the
wanted position.
3. Slowly pull clutch lever (A)
towards position (C). The machine
will start moving slowly.
IMPORTANT
• Do not force the speed lever.
• Do not change speed whilst
machine is on the go as this could
damage the machine.
How to stop the machine
1. Remove your hand from clutch
lever (A). This will stop the machine.
2. Place throttle lever (B) in “low”
position (C).
3. Turn engine switch into “OFF”
position.
4. To stop the engine, refer to
instructions mentioned in the en-
gine’s “Use and Maintenance”
handbook.
To Next Page
Loading...
