35
PROGRAMMING THE BEND SLOWING FUNCTION (Optional)
Note: The Infinity Stairlift
must be programmed as
normal; should slowing be
required please use the
following steps.
To slow The Innity
Stairlift when travelling
around the bends the unit
must be programmed the
following way;
Position the Stairlift where
you would like to start the
slowing function
Push button ‘2’ on the
main PCB board until a
beep is heard.
2.Push
321
1.Stop
3.Move
5.Push
321
4.Stop
Move the Innity
Stairlift Around the
bend to the position
where you would like
the slowing function to
stop then;
Push button ‘2’ on the
main PCB board until a
beep is heard.
The unit will now be
programmed to slow
around the bend.
To Next Page
Loading...
