Beta 1498LT/12 - Using Portable Starter - Forced Start; Using Portable Starter - Memory Saver Power Supply

13
ISTRUZIONI PER L’USO
I
INSTRUCTIONS FOR USE
EN
USING PORTABLE STARTER – FORCED START FOR BATTERIES WITH VOLTAGE UNDER 6 V
The “FORCED START” mode is recommended when a vehicle with completely or extremely at
or cut-off battery needs to be started. AS SOME SAFETY FEATURES ARE DISABLED, BE CARE-
FUL WHILE USING THE STARTER.
• Check that the starter is off.
• Find the post corresponding to the vehicle’s chassis; this is usually connected to the negative clip.
• Always connect the output lead with red clamp (+) to the positive post of the battery, and the
output lead with black clamp (-) to the vehicle’s chassis.
• Never reverse polarity; reversed polarity can cause explosions or damage to the vehicle,
the starter and people.
• When polarity is reversed, the “Reverse” RED LED is enabled.
• Disconnect the clamps from the vehicle and connect them correctly.
• Check that the cables of the starter are away from fans, moving parts and the fuel pipe.
• Press the START/STOP button for 7 seconds; the blue LED will turn on and “STRT” will start blinking
on the display. Some protection features are now disabled.
• Start the engine within 30 seconds.
• After 30 seconds the starter will cut out automatically.
• CAUTION! AS SOON AS THE ENGINE IS STARTED, CUT OUT THE STARTER AND DISCONNECT
THE CLAMPS.
• To cut out the starter, press the START/STOP button.
• Disconnect the output lead with black clamp (-) from the vehicle’s chassis, and immediately replace
it in its case.
• Then disconnect the output lead with red clamp from the positive battery clip (+), and immediately
replace it in its case.
If the vehicle cannot be started after the rst few attempts, do not try again. Before attempting a new
start, leave the starter to idle for at least 3 minutes, to prevent it from getting damaged.
• Charge the starter after each use.
USING PORTABLE STARTER – 12V MEMORY SAVER POWER SUPPLY
AS SOME SAFETY FEATURES ARE DISABLED in the “MEMORY SAVER” mode, BE CAREFUL
WHILE USING THE STARTER.
• Check that the starter is off.
• Always check the voltage of the vehicle’s battery.
• If the voltage of the starter does not match the voltage of the vehicle’s system, explosion,
or damage to the vehicle, the starter and people could occur.
• Find the post corresponding to the vehicle’s chassis; this is usually connected to the negative clip.
• Always connect the output lead with red clamp (+) to the positive post of the battery, and the output
lead with black clamp (-) to the vehicle’s chassis. Some protection features are now disabled.
• Never reverse polarity; reversed polarity can cause explosion or damage to the vehicle,
the starter and people.
• When polarity is reversed, the “Reverse” RED LED is enabled.
• Disconnect the clamps from the vehicle and connect them correctly.
• Check that the cables of the emergency starter are away from fans, moving parts and the fuel pipe.
• Press the START/STOP button for 5 seconds; the blue LED and the yellow LED will turn on
and “MEMO” will be displayed.
• Carry out the required operations.
• When the operations have been completed, press the START/STOP button to cut out the starter.
THE FOLLOWING OPERATIONS MUST NOT BE CARRIED OUT WITH THE “MEMO” FEATURE:
• the “MEMO” feature must not be used to start the vehicle;
• with the “MEMO” feature, the starter will not cut out after 30 seconds;
• before disconnecting the clamps, make sure that the starter has been cut out.
When the operations have been completed, replace the starter in a dry area free from humidity. To clean
the outside body, use a dry cloth.
1498LT_12.indd 13 10/11/16 09:14