EasyManua.ls Logo

Betta SE - Use of Anti-stranding Bars

Betta SE
8 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Status: the battery is very low, or battery becomes completely discharged.
Remote Mode: lights are in steady Green.
Status: the unit is controlled manually via a remote control.
Strand Mode: lights flash in combination of Red and Green.
Status: the unit's propellers or impeller is not working properly, most
likely it has been stuck by obstacles or cannot run freely. In this case it
will stop running automatically. The unit will try to restart every 20
minutes when it is in Strand Mode.
4.4 Use of Anti-stranding Bars
When to use:
If there are shallow stairs or other structures in your pool, Betta may be stuck on
it. You can adjust the built-in anti-stranding bars to solve this problem.
How to use:
Press the upper button on the bar housing and pull down the bars. Each bar can
be set in two positions in height. Adjust them in pairs – both front and/or both rear to
keep it balanced.
Retrieving the anti-stranding bars: Press the lower button on the bar housing and
push the bar up until it’s fully in position.

Related product manuals