EasyManua.ls Logo

Beuchat VX 10 Iceberg - Cold Water Use

Default Icon
116 pages
Go to English
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
VRT 30 - VRT 30 NITROX - VRT 30 “Cold type” / User guide > 37
C > Venturi lever
This lever, located on the side of the second stage
Housing, enables the diver to contr ol the inhalation
Venturi effect. When on the + position, the diver get
maximum Venturi assistance upon initial inhalation, the
air flow is maintained without additional ef fort.
Important : On the surface to avoid any fr ee flow resul-
ting from surface waves and / or sudden entry in the
water , the diver should keep the lever pushed towar ds
the front in the - / minus position. This position should be
maintained whenever the second stage is used as an
octopus for a safe second stage.
At the beginning of the dive, the diver should push the
Venturi lever in the + / plus position, to obtain optimum
breathing characteristics. The + / plus position is the "dive
mode" position.
Note :
The V30 first stage 3/8" LP ports can accommodate the
safe second stage octopus and the buoyancy compensa-
tor LP hose and / or drysuit inflator hose.
On the 7/16" HP ports, install a pressure gauge to check
air supply during the dive (right or left position).
A 3300 psi DIN connection kit can be installed on the
V30 first stage by a BEUCHAT authorized dealer.
A 3300 psi DIN to yoke adapter is available under r ef.
#16740 to allow the mounting and the use of a DIN regu-
lator on a standard K-valve cylinder.
2 - COLD WATER USE
Use of regulators in water temperature colder than 50 F /
10° C, requires special equipment and precautions.
Only the VR T30 “Cold type”, VR T80 Evolution, VX10
Iceberg, VX200 Iceberg, VR200 Soft T ouch, VR200
Evolution et VR200 Iceberg should be used in cold water
diving.
1. Make sure that your air supply meet the EN 12021 qua-
lity norm requirements.
2. Use a cylinder with a dual outlet Y-valve and two inde-
pendent breathing system outfitted for cold water use.
3. Do not expose the regulator to cold air (colder than 32
F / 10°C). Place the regulator first stage in the cold water
to bring its temperature up before use.
4. Do not purge the second stage outside the water to

Table of Contents

Other manuals for Beuchat VX 10 Iceberg

Related product manuals