Beverage-Air MT Series User Manual

User Manual for MT Refrigerators and Freezers Beverage-Air
Rev. 10/22 Beverage-Air 13
Condenser Cleaning
The condenser must be cleaned once a month, or when required to avoid dirt from reducing cooling system eciency.
To clean the condenser, the front grille will need to be removed as shown in the illustration below.
Remove dust, lint, and debris with a soft bristle brush or broom.
In kitchens and/or cooking areas where grease may accumulate, the condenser may need to be cleaned with water and
degreasing agent.
IMPORTANT: Do not use solvent or abrasive products for cleaning as they may damage the surface.
Do not use sharp pointed objects to remove grease, use a brush if required.
Evaporator Defrost
This product is equipped with an automatic evaporator defrost system to guarantee adequate interior air ow.
If you notice ice forming and/or equipment is not cooling properly, contact the Beverage Air Technical Service Center for
assistance.
Plastic Evaporator Housing
1. Unscrew the drain nut
2. Remove the drain hose
3. Remove (A) screws from the evaporator housing
4. Remove the plastic evaporator housing
Tube Cover
1. Remove the grilles
2. Unscrew the xing points of the tube cover
3. Remove the screws from the tube cover
4. Remove the tube cover

Beverage-Air MT Series Specifications

General

Brand	Beverage-Air
Model	MT Series
Category	Commercial Food Equipment
Language	English