english
A 2 – Operation
19
Operating Instruction for the Example of Application
• Connect a CD player to the input 1 on the A 2.
• Connect the output 1 on the A 2 to the CD input of the power amplifier.
• Connect the “AUX Out” or “Tape Out” output of the power amplifier to the input 2 on the A 2.
• Connect one or two headphones to the headphone connection . Depending on the efficiency and the impedance
of the headphone, select the gain and the output impedance at the bottom of the A 2.
• Connect the A 2 via the mains connection to the mains.
Warning: Before connecting the A 2 to the mains, please check if the voltage range selected with the voltage
selector switch corresponds to the local mains voltage. If you connect the device to a different mains voltage
or if you change the position of the voltage selector switch during operation, a short-circuit can occur inside
the device and cause damage to the device.
• When the A 2 is connected to the mains, the standby button will illuminate red.
• Turn on the A 2 by pressing the standby button on the A 2 or the button of the remote control. The standby
button will illuminate green and the button or will illuminate orange, depending on which input was
active when the A 2 was turned off.
• Now you can select one of the two audio sources with the buttons or on the A 2 or with the buttons or
of the remote control, i.e. with the button for input 1 or you select the CD player or with the button for
input 2 or you select another device connected to the amplifier such as a TV, DVD player, tuner or phono
player.
• The signal of input 1 is also permanently available at output 1 . This means you can listen to the looped-
through audio signal via your hi-fi system, even when the A 2 is turned off.
• Select the desired volume with the volume control or via the remote control .
• If the headphone is to be muted temporarily, press the mute button of the remote control. The orange illumi-
nating button or of the selected input 1 or 2 will go out. Deactive mute by pressing the mute button once
again or by pressing the volume control of the remote control.
• In order to turn off the A 2 press the standby button on the A 2 or the button of the remote control.
• An intelligent, microprocessor-controlled relay ensures silent switching between the two different audio sources
and avoids unpleasant noise or damage to your hearing should a power failure occur or when turning the A 2 on
or off.
To Next Page
Loading...