Front view
1. Backlit on-off switch.
Red = Device is in stand-by mode.
Green = Device is turned on.
2. Headphone sockets, connected in parallel, 1/4″ stereo jack (6.35 mm).
In order to connect standard headphones.
Important:
As the headphone sockets are connected in parallel, the volume is controlled for both headphones. Therefore,
we recommend using headphones of the same impedance to achieve the same volume for both headphones.
3. Volume control to adjust the volume.
Warning/hearing protection:
We would like to point out that listening at high volumes over a long period of time may damage your hearing
irreversibly. Therefore, reduce the volume before putting into operation and when changing the audio source, as the
connected devices or reproduced audio data can have very different output levels.
Make sure that the set volume is not too high. Rule of thumb: The higher the volume, the shorter the time of listening.
According to employer’s regulations for safety and health the noise exposure e.g. when working should not exceed
85 dB (low volume). This is an allowed time of listening of 8 hours at maximum. If the volume is increased by 3 dB,
the allowed time of listening is halved, i.e. with 88 dB the time of listening is 4 hours, with 91 dB 2 hours and so on.
Rear View
To Next Page
Loading...
