Beyerdynamic AVENTHO Wireless - Optimizing Sound Quality; Playback Device Settings

english
Aventho wireless – Headphones
17
Headphones LED display table
Charging red LED flashing
Fully charged LED permanently lit
Switching off LED lights up one time for 1.5 sec.
Battery almost empty red LED flashing fast 3 x
Bluetooth connection mode active
(Pairing)
red and blue LED flash alternating
Bluetooth connection active blue LED flashes slowly with interrup-
tions of 7 sec.
Bluetooth connection lost blue LED flashes slowly with interrup-
tions of 3 sec.
Media playback active blue LED flashes slowly with interrup-
tions of 7 sec.
Incoming call blue LED flashes fast with interruptions
of 1 sec.
Playback device settings for your best wireless sound
To achieve your best possible Bluetooth sound with Aventho wireless, you should
consider the following practical hints:
•
Set the volume of the Aventho wireless to minimum, of the playback device to
maximum. From then on, adjust the volume on the Aventho wireless only, not on the
playback device. This applies only to playback devices that do not automatically
synchronise the volume.
• On playback devices that automatically synchronise the volume (e.g. iPhone, iPad,
various Android smartphones), the headphones volume is always identical to the
volume of the playback device.
• Deactivate any audio effects that might exist in your player software.
• Ensure that aptX™ HD is switched on at the Aventho wireless, if supported by your
playback device.